Perhaps one of the most iconic sweets gets its own day of national observance. Is there any childhood commercial more iconic than the little boy asking the wise old owl “How many licks does it take to get to the Tootsie Roll center of a Tootsie Pop?” My take on this classic may not be as complex, but it is equally delicious.
The classic lollipop is simply sugar cooked to the hard-crack stage in the candy progression. If you have never done this, be sure to have an accurate candy thermometer and a safe workspace. Do not get the hot sugar on you, and work cleanly and carefully.
- 1 cup sugar
- 1/2 cup light corn syrup
- 1/4 cup water
- Dissolve your sugar and corn syrup into the water in a large, thick-bottomed pan.
- Heat gently to ensure the mixture is completely dissolved, then increase the temperature to medium high and insert your candy thermometer.
- Boil, undisturbed, until it reaches 295F.
- At this point, remove from heat and stir in any extracts or food coloring you might want.
- Shake the pan vigorously to ensure that it is thoroughly mixed.
- If you are using molds, spray with non- stick spray. Fill these molds and insert the stick before it gets too cool.
- Allow to cool completely and serve.
- For a more advanced technique, you may need sugar pulling gloves. Take the hard crack sugar, after the additions are made, and pour it onto a Silpat over a heat protective surface. I like to use a thick cutting board just in case the counter isn't quite sturdy enough. Allow the liquid to cool enough that you can start to pull the edges inward. It will be like a very thick, very hot gel, that solidifies as you work. Continue pulling the edges inward and letting it cool, until you can remove the entire pool of sugar. Now pull the sugar out and twist it back onto itself. Continue pulling, twisting, wrapping, tucking, and bringing the mass back together. This will change its color and texture considerably. The air will create a popping sound in the sugar and you will start to see a shine. While still pliable, pull a length out and roll it on your silpat to create an even diameter tube or coil. Then start coiling this upon itself tightly. Continue wrapping the circles around themselves until you have the diameter lollipop you want. Quickly place the stick into the coils and pull it aways from the center to create a gentle teardrop seal between the stick and the candy. Allow to cool completely lying on the board, so it won't sag during cooling. Now you have the very classic, very iconic, twisted lollipop.
- For more daring candy makers, pour out some of your sugar and color differently, then wrap that around your initial coil to create that candy-striped appearance. And don't forget that you can add any kind of alcohol of flavoring to these candies as long as they are reduced to an extract state.
Joe the Baker https://www.joe-the-baker.com/